Steve and Ron lifting the Overhead assembly into place for some trial fitting.

The Overhead resting in its new spot thanks to some nifty work. The aft section will eventually house the Overhead Circuit Breaker Panel. Once we have our Engraved caps and the AML switches up we'll tackle that job!

SgSteve checks out the new look of the sim. Still alot to do up there but its very encouraging to see this section go up. Very special thanks to my friend Achim who was dying to show everyone his Nova Overhead but waited for me to have this special moment! Thank you Sir!. Looking forward to starting on the Glare and Main area and some more wiring. Lots to do. Might even take her for a whirl!

Here I am dropping some bolts through the roof of the shell.. Ron is below bolting them in to brackets and reinforcing the whole shell Roof section.

Another rare shot. Me doing some work! Once in awhile Steve and Ron let me do the odd bit.

Steve and Ron working out the postioning of the Overhead Framing.

Steve and Ron .

Ron and Steve checking out the fit again. Really important to get this right. Ron is looking at the potential of having the Entire Overhead assembly lower down, pivoting from the front. Great idea if he can do that. Would make wiring changes and reppairs easier.

 

 

For More Detailed Information On Project Megenta Software Follow This Link!