744 Manual & Assumed Temps

[744pilot 0]

ramon@pyreneseberghonden.be or ramonkemmerling222@hotmail.com

[cougar2501 2]

Could someone forward me a copy as well please.phil@densleyp.freeserve.co.ukMany ThanksPhil Densley.Melksham.UK.http://www.precisionmanuals.com/images/forum/800driver.jpg

[victorlima01 2]

Just sent it to the first couple of guys. If any of you don't get a copy from them by the end of this week let me know. ;)Best Regards,Victor Limahttp://www.precisionmanuals.com/images/forum/800driver.jpg

[Guest Hawkeyeted]

Appreciate a copy....hawkeyeted@adelphia.net

[michal 44]

Me too ...panmichalDELETE@gmail.comPlease remove the "DELETE" part.Michael J.

[victorlima01 2]

So, did everybody get it? Remember this spreadsheet was built based on the Aerowinx 747 engine parameters and thrust logic therefore the derates are probably not as close as we might like. But it still works just great for giving you speeds and other information. Just remember one thing, which is to select an aircraft with the same MTOW as our PMDG (for example use LX-GVC as aircraft ID). Another thing I found is that you will not get a derate if you manually select a flaps 20 for takeoff. It will always end up telling you to use maximum thrust. You have to leave the flaps selection to auto and then press calculate to get a derate. The derate and the speeds will obviously be based on the flap selection that the spreadsheet chose. If you really want to takeoff with flaps 20 I suggest going through this process to find the derate and then entering flaps 20 and calculate again so that you'll find the adequate speeds for that flap setting. The obvious problem is that since derates are also flap-dependent you'll end up with an N1 figure that is not accurate. But until they find a way around this I'm happy using this spreadsheet. I hope the developer will create a new one. Best Regards,Victor Limahttp://www.precisionmanuals.com/images/forum/800driver.jpg

[Guest glide]

me too pleasek.lavrihDELETE@ntlworld.complease remove the delete partthankskav

[michal 44]

I did not get it.Michael J.

[Guest Hawkeyeted]

Nor I.

[Bina 59]

Hi,Can i have one copy either? Thank you very much for your support. My email is: vuqar76@yahoo.co.ukThank you once again.Vuqar QuliyevFrom Bina Intl. Airport (UBBB), Baku

[ealim 0]

Hi, I would sure like a copyealim@chello.noBest regards,Eirik Alim

[Marius_S 4]

Bump...Haven't recieved any mail yet... marius558@gmail.com

[Guest d809dp]

Hi guys, I would really appreciate a copy please! :-)t.registrations@sylvesteruk.comThanks a million and Merry Christmas!Tom!

[horace 3]

hendrik[ dot ]horeis[ at ]gmail[ dot ]comthank you guys in advance!

[Iain Sealey 1]

I wouldn't mind a copy myself:777[at]speedbirdonline.co.ukoriain[at]bavirtual.co.ukoriain.sealey[at]ntlworld.comCheers