Autoflight misbehaviour

[ashigar 0]

Fellows,Since the installation of the -400F and the latest patch, I have been experiencing a change of behaviour from the autopilot mode. I have to say I am using FSUIPC ver 3.53 and Activesky Ver 6 patched. This has happened twice both of them from the RR engines however(Cargolux & BA PAX. With everything going accordingly and some hours (realtime) into the flights, I hit turbulance and all of a sudden the commands will change to FLCH and starts a decend and will not take any cammands given there after. Even with full CRZ settings engage, speed is reduced with the 'stickshaker" going off all over. This with FMC program to a FLXX, but FLCH will decend the Aircraft to the lowest possible Altitude and continuing even if I set a higher ALT on the MCP, it will not honor that command. Again no inputs from the pilot is accepetd if this occurs. Is anybody else experiencing this? ThnxGus

[Guest D17S]

Turbulence? Well maybe that too, but you were back playing cards with the loadmasters, weren't you? Ahh, the adventure! During an extreme under speed situation, coach AFS (autoflight system) will kick out the VNAV PATH/SPD mode team and swap in its relief pitcher "FLCH SPD" and its power hitter "THR" to save the day. You probably noticed your airspeed was way down. I call this maneuver the "Falling Leaf." THR will take power to EICAS thrust limit. FLCH SPD will pitch down to regain some airspeed, but then once it gets some, pitch back as it attempts to trade this newly acquired zoom for altitude. Of course this pitch up just slows the airplane down again and the cycle continues . . . all the way to the dirt. The "FLCH" and "SPD" parts of the FLCH SPD pitch mode are fighting each other. The FLCH part wants to reacquire your MCP altitude and the SPD part wants to accelerate. Speed has the highest priority, so the initial maneuver is to pitch down. Once FLCH SPD thinks it