Jump to content
Sign in to follow this  
Followers 0
Guest

After new panel install frame rate down to 1 or zero!

By Guest, in MS FSX | FSX-SE Forum

Recommended Posts

Guest   

Guest
Posted

I recently installed a new panel (raylear2.zip) ((not suggesting the problem is with the panel)) and found with that plane, when loaded, I got a frame rate of 1 or zero! after just a couple of seconds.I believe I followed the install instructions and just before the panel install everything was fine and flying.I then removed the panel and set the airfile back but no change. Moreover any aircraft now exhibits this same effect.Is there an obvious reason for this or shall I have to re-install FS2002?ThanksNigel

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0
Go To Topic Listing

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...