FSBUS and Setting Up Flight Yoke

[FLYINGJB 0]

Hi all...I made a new yoke out of 2 pots. I am using FSBUS and can't seem to set the aielron and elevator up to neutral when yoke in neutral position. If I look at the plane from the outside my ailerons are constantly in the position to bank right...even though the yoke is centered in my ####-pit. Can anyone tell me the correct FSBUS settings I should have ? Here is how I set them up (but I'm not sure what I'm doing !):MULTIPLIER 95MAX VALUE 16383MIN VALUE 7000 (This is the lowest number I get when I turn yoke)OFFSET VALUE 0CENTER VALUE 118 (Not sure what this means so this could be the problemCENTER WIDTH 5If anyone has any ideas or can point me in the right direction I would certainly appreciate it...all the best....JB

[FLYINGJB 0]

Hi all...I've done a little more checking....1) When I rotate my 100k pot I get readings in FSBUS AD of between 128 and 161922) If I look at the airplane aileron position gauge it shows they are centered at 128 and full right bank at 161923) I don't seem to be able to get the pot to bank left with the settings I have and the full pot rotation...only centered to right bannk !!Any ideas anyone ?Thanks a bunch for your help...JB

[fvapres 7]

straighten up and Fly RIGHT???sorry. Had to say it.

[tigert 0]

Are you sure the potentiometer is *linear*?//T