Dash 8 throttles won't move! :(

[Guest]

Hi :)I've got the engines, panel etc going on the new Dash 8 .... but the throttles won't increase.... the levers just move as if they are jammed :-hmmm. I can adjust the prop condition levers etc.. what's going on :-hmmmThanks :)

[FTD1949 0]

It says in the instructions (not sure where) that you MUST have a joystick with a throttle control and use it instead of F1-F4.Hope that helps you.

[Guest Grunt]

Same here. I'm using Flight Sim Yoke USB and cannot get the condition levers to move. Also, the L and R throttles will not sycn. I add power and they "snap" to where they should be (both at the same thrust) but then they kind of just drift apart (especially the left one). Using FSUIPC 2.88. Any ideas?http://www.flightsimnetwork.com/dcforum/Us...cdf6182b41d.jpg Great Lakes Express VA - The Midwest's regional and feeder airlinehttp://www.voyagerairlines.com/gle/index.html

[Vulcan 14]

Have the same throttle problem here & using FSUIPC to set null zones and travel but have a different throttle than the Flight Sim Yoke.Once the joystick in FS2002.cfg is locked FSUIPC should be able to set the sensitivities without having to set them by the FS Sliders.Wil have another go later in the week.

[Guest Vulcho]

Did you guys unlock the levelers?If you press F3 you see the throttle quadrant. Enlarge the thing as it is hard to read-(as most of the panel). There, on the top you will see a lock that you must unlock. Press on the top left side somewhere where the lock is and you should be all set! It took me 30 minutes searching how to do this.http://turnhead.com/dot/alex/banner-retro-cool.gif