What to do with redundant CH yoke throttle levers?

[Guest gb anon]

I have a CH yoke and a GoFlight throttle quadrant,which leaves the three CH levers with nothing to do.Anyone have any interesting ideas onwhat the CH levers could be assigned to do?(Flying GA and Heavies)Thanks,gb.

[geoffco 0]

Hi,In my setup, I have a CH yoke and CH throttle with the six levers as spoiler, 4-throttles and flaps so I also have the three redundant levers. I have disabled one of these (the throttle) and set mixture and pitch on the others for the rare occasion I use props - then when I'm not using them, I have a small black box which fits over them to keep them out of view and prevent my knocking them.Geoff

[orchestra_nl 925]

I have one of these assigned to cowl flaps and another to elevator trim. I haven't found a use for the third one, but still looking...I like the elevator trim especially. It may not be a wheel like in real life but at least a lever is better than just keys. I can't check now, but I think I needed FSUIPC to make the cowl flaps work.Cheers,Allard.

[Howiefly13 30]

I use one for the spoilers.

[cshark172 20]

I have one for cowl flaps, and another for Gear lever. Nothing on the third one at the moment. Need to use FSUIPC to assign gear lever.Kylehttp://www.precisionmanuals.com/images/forum/747400.jpg

[Guest gb anon]

Ok,thanks for the ideas.gb.

[boris4356 4]

I use one for flaps.Bill

[B42L8 0]

these are great ideas, I tried to use one of the yoke levers for landing gear, but it only works for buttons, how do you get it to work with an axis??