Sign in to follow this  
Guest Brisbane Bound

Saving Dash 8 Flights

Recommended Posts

I have been saving flights half way through so I can come back to the flight later. Problem is when I open the flight up again not all of the controls and switches are where I left them (on or off etc). I usually pause the flight when it opens and reconfigure all the controls back to where they should be. I have to turn on the AP and reset the ALT/SEL etc. Have to turn on some of the overhead panel swithces and re-initial the FMS and load the route back in.Engines are running (which is good).Is there a way to get it to save all the configurations correctly?Note for the uninitiated, make sure you deselect "Start with engines off" and "Start with a cold and dark cockpit" in the Panel Config. Bit hard to start the A/C up from scratch at 24000 ft.Any help appreciated,ThanksStephan

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Sign in to follow this