Archived

This topic is now archived and is closed to further replies.

pkofman

livery install for dash 300q

Recommended Posts

I bought the liveries for the pss dash 8 from pss, what I wanted was a livery for air canada or jazz colour for the 300q. I got all of the jazz colours for the dash-300 There are no air canada or jazz colours provided for the 300q . Can someone tell me if I can rewrite the .INF file to apply the jazz livery to the 300q aircraft.. it looks pretty easy but I could not get it to work. Thank youpeterPeter K P.EngCF-MMZToronto Ontario CanadaPMDG 747,737and 747FLevel D 767PSS Airbus pro A340-300In reality, a Mooney 201 Pilot

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Hi,I would:(a) Copy the appropriate JAZZ texture sub folder to the Q directory(:( Copy the JAZZ [fltsim.x] section(s) of the 300 aircraft.cfg to the Q300 aircraft.cfg and adjust the .x numbers in a way that you have contiguous numbering.Normally this should work.RgdsReinhard

Share this post


Link to post
Share on other sites

Thank you are correct,It worked perfectly, Ive been at this long enough and should have been able to fiqure that out.Thank you for your assistance and helpregards Peter

Share this post


Link to post
Share on other sites

Hi:An even easier solution is to go to the PSS Dash 8 folder and open the 'aircraft.cfg' file. Under 'flightsim.0' (or whatever) you'll see 'title=PSS Dash 8 300 "Q" Rollout', and a bit further down 'texture=house'. Change to 'texture=jazzred' (or whichever colour you prefer) and you're there!Good luck,George[EGKA]

Share this post


Link to post
Share on other sites

Hi:I downloaded the Air Southwest pss textures and put thwm into the folder and copied the writing into Aircraft.cfg, But it did not seem to work. Can anyone help?

Share this post


Link to post
Share on other sites

Dale we're going to need a bit more information than that.FS9? FSX? What exactly did you copy over and did you "edit" any of the text etc? Can you paste the info you copied over to the config file along with the names of the other folders you placed too.D777

Share this post


Link to post
Share on other sites

FS9. When i downloaded the textures i read the read-me file and where it said copy and paste the text below and change the x to the number, I done that. I put the texture folder and it did not work.

Share this post


Link to post
Share on other sites