Resuming Flights A330/340

[hippyonenine 1]

Hi everyone.I notice that when I need to resume flights the planes load fine but the displays are blank even though my batteries are fully switched on and the avionics as well.I muat be missing something here! Would appreciate any assistance.ThanksJohn H

[Guest Phoenix_7]

try switching to a default aircraft then back to the 330/340also it is not possible to resume flights with all switches saved as you saved the flightJohn PSS SUPPORTsupport@phoenix-simulation.co.ukhttp://www.avsim.com/pss/phoenix.jpg

[hippyonenine 1]

Well it works to get the aircraft back with the display but I cannot get all the switches back to where they should be before the plane stalls so I am still unable to restore properly. John

[Guest Phoenix_7]

continuing saved flights with all switches correct is not possibleJohn PSS SUPPORTsupport@phoenix-simulation.co.ukhttp://www.avsim.com/pss/phoenix.jpg

[Guest andrew59it]

I usually save a flight normally, and when I reload it I place the sim in pause, load the flightplan ino the mcdu, put the value into the init page, set thrust at climb, push autopilot and auto autothrust buttons and then un-pause the sim. Usually it works fine and it take one minute for the set-up.Andrea