Sign in to follow this  
jay907uk

No strobes/wing lights/beacon/nav light flashing

Recommended Posts

Hi,Wondered if anybody could help I went on my A319 and noticed after I started it up etc there was no lights flashing for the above anyone have any suggestions?Secondly When I took of the aircraft climbed to quick after I pressed AP and the speed contiuned to increase is there anyway to stop this I used a SID from EGLL and my altitude was mean't to be 3500A but it got to that altitude before reaching the waypoint hope this bit makes sense???Many ThanksJason Thompson

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Lights: did you turn them on in the overhead panel? If so and they still weren't showing make sure the PSS-beacon, PSS_light, PSS_logo, PSS_strobe_Airbus,PSS_navgre and PSS_navred, are in the main fs9 texture folder.Speed: did you have the 250/FL100 altitude constraint in the Vert Rev page of one of the fixes below Fl100? You can check this by clicking the line select key (LSK) to the right of one of these fixes and entering that constraint at LSK2L (line select key 2 left) if it isn't already there.Altitude: when you were on the climb in the SID did you make sure that the altitude constraints of the SID were in the F-PLAN page of the MCDU? Did you also make sure you had dialled the altitude you wanted to climb to ultimately, normally 6000 ft on SIDs out of EGLL, into the FCU on the glareshield? Also did you then left click (press) the alt knob to go to managed alt?Rob Elliott, EGPE InvernessPSS Airbus Support andAirbus Fleet Training Captain, British Airways Virtual airbus@speedbirdonline.co.ukhttp://www.speedbirdonline.co.uk/airbus.htmlhttp://www.bavirtual.co.uk

Share this post


Link to post
Share on other sites

Hi Rob,Many Thanks for your reply and advice. Those files you said they are not in my main fs9 texture folder at all I have checked several times.Would that mean I need to uninstall the PSS Airbus Aircraft and then re-install them again or is there a different way to do it.Many ThanksJason Thompson

Share this post


Link to post
Share on other sites
Sign in to follow this