Pitch trim fine tuning

[Guest RonB49]

I have found a way to fine tune the pitch trim on the TinMouse 732 (or any plane, for that matter). Here's what I did. I accessed the Fs9.cfg config file and found this section:[CONTROLS]KBDAIL=64KBDELEV=64KBDRUD=64And changed it to:[CONTROLS]KBDAIL=64KBDELEV=22KBDRUD=64Now I use the CH Yoke rocker switch under my left thumb for course pitch trim and the NUMPAD 1 and NUMPAD 7 keys for fine pitch trim. It seems to work better for me. You can adjust the KBDELEV number to increase or decrease the sensitivity.R-

[Guest Bill Hinton]

Ron,Thanks for this. It sure helps.

[graemeb 14]

Don't forget to also check your FS9 button assignments to make sure that elevator trim repeat rate is at the half-way mark (not full). This helped me on my system (CH Yoke).