Autobrake & Flaps

[Guest sandro becker]

Bob,I deleted fsuipc.ini and let it default. I reset all FS9 config to default.I use your last .air and 1.23a gauge. I use ffx aircraft.cfg.The speed brake continuos to desarm after nose gear touch. The spoilers only deploy when aplying reverse. Is that ok?RegaRDS

[Guest daniel.alm]

>Bob,>>I deleted fsuipc.ini and let it default. I reset all FS9>config to default.>I use your last .air and 1.23a gauge. I use ffx aircraft.cfg.>The speed brake continuos to desarm after nose gear touch. The>spoilers only deploy when aplying reverse. Is that ok?>>RegaRDSI think that happens in my installation as well. I also have the registered FSUIPC, version 3.74.

[Bob Scott 7,720]

OK, two issues here.First, if you're not getting spoiler deployment until the TRs are deployed, it means your throttle inputs on one or both engines are something greater than zero. If you are using a single throttle control, make sure that the "Map to 4 throttles" option is checked in the FSUIPC Joysticks tab, page 1. And make sure your joystick is calibrated to have enough dead zone at the bottom end to always read 0 when pulled back to idle.The other issue is the autobrakes. I do see a problem on one of my machines with a simple DirectX joystick controller. I've spent a few hours with it, and it's not going to be easy to fix. For now, accept that your autobrakes are placarded inoperative. They work fine with my PFC flight controls, which use axis control via FSUIPC, but there is a problem with keyboard/button brake control and autobrakes.RegardsBob ScottATP IMEL Gulfstream II-III-IV-VSantiago de Chile

[Guest sandro becker]

>OK, two issues here.>>First, if you're not getting spoiler deployment until the TRs>are deployed, it means your throttle inputs on one or both>engines are something greater than zero. If you are using a>single throttle control, make sure that the "Map to 4>throttles" option is checked in the FSUIPC Joysticks tab, page>1. And make sure your joystick is calibrated to have enough>dead zone at the bottom end to always read 0 when pulled back>to idle.>>The other issue is the autobrakes. I do see a problem on one>of my machines with a simple DirectX joystick controller. >I've spent a few hours with it, and it's not going to be easy>to fix. For now, accept that your autobrakes are placarded>inoperative. They work fine with my PFC flight controls,>which use axis control via FSUIPC, but there is a problem with>keyboard/button brake control and autobrakes.>>Regards>>Bob Scott>ATP IMEL Gulfstream II-III-IV-V>Santiago de ChileI will check my throttle issue. Bob,Did u read my email about a 732 in Brazil? I apreciate a lot an answer!Regards