PDCR Display Blank

[j14g 0]

Hi Bob,I had to reinstall TM2. My previous install worked perfectly but now I can't get the PDCR to run. It's already set to STBY but the display is blank.I've reinstalled a couple of times but to no avail. I also tried going through the powered up C172 at KSEA, but still no display on the PDCS.I've double checked the Modules to make sure the correct .dll files were in place.Any idea what I could try next ? Thanks,Jack

[Bob Scott 7,716]

A couple of possibilities:First, make sure you don't have a typo, duplicate gauge number etc in the panel.cfg file on the pdcs_cdu gauge line.Second, you need one of the main busses powered to run the PDCS. Make sure you have the electrical panel configured correctly, and that you have either APU or engine generator power connected.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO

[j14g 0]

Thanks for the help, Bob Activating the APU did the job.Fly high.Jack