Elevator Trim stuck?

[Guest]

I am sure I have seen this before but my search doesn't bring any relevant information: When I load ANY plane, my elevator trim is set all the way down. If I try to change it, it returns to the original position as soon as I stop hitting the keboard. I ave removed FSUIPC to be sure, and have checked my key and joystick assignments, to no avail. Has anybody got an idea?

[wb5okj 26]

Hit the,"Z", key to turn off the AutoPilot. Sounds like you saved your startup flight and inadvertantly turned on the autopilot. Worth a try anyway. So if you hit the "Z"key and get a tone, you know the autopilot was on, and I would then resave the startup flight.Hope this works,

[Guest]

Tried it but no, the AP is off, so it's something else...Thanks anyway!

[ronzie 21]

Try reassigning the involved keys to force a new config setting. Use a different available key and see if that works, then put it back and try again.The may be a config file problem.

[Guest]

Thanks, but it didn't change the results... It's weird, I have deleted my FS2002.CFG, reassigned keys and joysticks actions, removed FSUIPC, and whatever plane is used, TRIM goes all the way down within 2 seconds of loading the plane, almost like a failure of a plane system??

[Guest]

Same problem here trying to fly a C-150. I read replies and suspected perhaps it was the model itself.It was. Free stuff is, well, sometimes not all it's cracked-up to be.All other planes in my collection fly just peachy. Many of them are free too.YMMV