Jump to content
Sign in to follow this  
nudata

FSX "Real Weather" - discrepency?

Recommended Posts

Temperature rises with altitude increase? Over Logan Utah. The airport reports a lower temp than shown when at altitude above the airport. Aircraft shows 40deg while 32 on the ground. If I place the aircraft on the ground the weather parameters match. Is the 40 degrees a creation from FSX or is it from the "real weather"?


regards,

Dick near Pittsburgh, USA

Share this post


Link to post
Share on other sites
Guest byoungblood

If you pass over a frontal boundary or temperature inversion, what you experienced is entirely possible.

Share this post


Link to post
Share on other sites
If you pass over a frontal boundary or temperature inversion, what you experienced is entirely possible.
That is interesting. Does FSX model the striations or is this from Jeppesen? I justwent to an airport near me and the reported condition were reasonable. Donig e vertical slew I had a logically stepped reduction in temperature from 19F down to zeroF. Therefore, I would have to tacitly agree that odd temperature layers may be properly found in FSX.

regards,

Dick near Pittsburgh, USA

Share this post


Link to post
Share on other sites

Something to be aware of...If you use FSUIPC there are a couple of options that need to be disabledotherwise you may experience an unabated increase over time of OAT.The options are 'off' by default but if a user enables them, then a problem can occur.Here is a link to a thread with the information and screen shots describing the potential problem. Look down the thread 5 or 6 poststo the post by me.http://a2asimulations.com/forum/viewtopic....=55&t=13228 Paul


Wide-5.jpg

Share this post


Link to post
Share on other sites
Guest byoungblood
That is interesting. Does FSX model the striations or is this from Jeppesen? I justwent to an airport near me and the reported condition were reasonable. Donig e vertical slew I had a logically stepped reduction in temperature from 19F down to zeroF. Therefore, I would have to tacitly agree that odd temperature layers may be properly found in FSX.
If you have FSX download winds aloft data with the other weather information, I assume that it imports the temperatures aloft as well. If it has that information, along with prog charts, METAR/TAF, etc., I imagine it can do enough modeling and interpolation to simulate temperature layers as well.

Share this post


Link to post
Share on other sites
Guest napamule

Paul,This one's for you: IT'S FSUIPC!, IT'S FSUIPC!, IT'S FSUIPC! Wow, that felt good. Too bad you can't say this, as FSUIPC is such a FANTASTIC program, and this is the ONE time I can jump up and down, point fingers at FSUIPC, jeer, cheer, and dance, yuppeeee, hahaha. There! (heehee).Now go uncheck that OPTION that FSUIPC so graciously provided ('just in case') and rest assured that something ELSE will be the 'problem' (and not FSUIPC - 'again'). But it may EVEN be the SOLUTION to someone else's (Microsoft?) 'booboo' programming. Cheers.Chuck BNapamule

Share this post


Link to post
Share on other sites

Temp inversions can produce a shocking temp differential, we get them in the winter in the PNW. We had a wicked one in Jan, which lead to weeks of endless fog that never burns off. Sea level temp of 34 F and dense fog, and at 2522 F msl no fog and a temp of 61 F

Share this post


Link to post
Share on other sites
Temp inversions can produce a shocking temp differential, we get them in the winter in the PNW. We had a wicked one in Jan, which lead to weeks of endless fog that never burns off. Sea level temp of 34 F and dense fog, and at 2522 F msl no fog and a temp of 61 F
My most shocking one was a few years ago coming from Florida to Mcminville, Tenn. The forecast was great, and temps were warm at 6000 ft. -around 55 degrees. When handed off to approach I was asked if I had any icing conditions? What the hay? Got the descend to 3000 ft. and the temp dropped to freezing and suddenly ice was accumulating at an alarming rate even with boots going. Landed, got the forecast-bad icing over the whole area and decided to spend the night and wait for better despite knowing I'd be late for work the next day. A huge area of unforecast icing overtook the whole area-and yes temp inversions. Tookoff the next morning and made home in nice vfr conditions-unfortunately quite a few aircraft that did not wait it out did not make it. I was suprised when my boss was happy I was late to work as a crash only a mere 10 hours before wiped out a whole family that tried to make it a go in those conditions.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...