Jump to content
Sign in to follow this  
ExpressJetXE

Crossing Restriction

Recommended Posts

HelloI fly alot into IAH. There is a 280k restriction at TXMEX and RC dont see this. It does have a FL140 restriction and it does tell me to desend below that to FL120. Is there anyway to make adjustments to reconize the 280K restriction?TnxEddie

Share this post


Link to post
Share on other sites

RC4 does not issue speed restrictions except for the under 10,000 foot restriction of 250 KT and 230 to 210 KT in what it recogniozes as the airport local area. You should be getting a 230 or 210 KT speed restriction at CRVZA.Note in the attached extract of the TXMEX arrival it states that turbojets are expected to cross as 14,000 feet (in FAA land flight levels start at 18,000 feet as FL180), not FL140, key word being "expected" so a 12,000 foot crossing is OK here. If it was a hard altitude it would be depicted at 14000 with an over bar and under bar.

HelloI fly alot into IAH. There is a 280k restriction at TXMEX and RC dont see this. It does have a FL140 restriction and it does tell me to desend below that to FL120. Is there anyway to make adjustments to reconize the 280K restriction?TnxEddie

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...