Black & transparent livery textures

[F.Schmid 0]

Patrick and DanThanks for your suggestions.I'll make some tests to minimize the 'skeleton effect'... :( Kind regardsSchmid

[asanal 31]

Patrick and DanThanks for your suggestions.I'll make some tests to minimize the 'skeleton effect'... :( Kind regardsSchmid

Do you have same problem with FS DX10 review mode? Sanal

[AdiR 27]

I've tried to lower settings (scenery complexity etc.) even to minimum and still have aircraft skeleton and black textures effect

[vscimone 16]

I've tried to lower settings (scenery complexity etc.) even to minimum and still have aircraft skeleton and black textures effect

[pete_auau 1,152]

Hi i had this problem too, but after a 2 second delay the textures came back to normal. So now b4 each flight i have to set the sliders for each aircraft to the settings that suit my pc, which takes an extra few seconds extra. Since now after trial an errors found what settings i need to set for the sliders in each aircraft.

[AdiR 27]

Peter what sliders did you set? I've reinstalled everything and problem still exists.Airplane does not "recover" after few seconds and stays black & transparent. My system is fresh, up-to-date, have newest drivers, hard drive is defragmented etc.Removing overclocking have didn't help here.

[pete_auau 1,152]

hi the scenery sliders i moved to normal both of them(complexity and the autogen density), if it doesnt work for u move all slider back to zero, and than gradually move one at a time back to half way till problem solved this wat i did. takes awhile till u get it right for each aircraft.

[AdiR 27]

I found some kind of solution but it's not good for people flying online. When you see black/transparent textures (skeleton) just decrease your Global Texture Resolution (for example to "Low"). Aircraft textures come back to normal and now you can move your Global Texture Resolution slider back to "Very High".

[Turbine777 13]

Hi Adrian, The thread you may want to check out is here. Looks like they posted a better fix if you don't mind a little sifting through the posts.