ground crew

[kasiday1 0]

what command switches from ground crew to after engine starteven though ground crew dismissed with thanks for the guidance see ya

[JET 1 0]

Mode should change from S/CREW ENG START to AFTER ENG START automatically once both engines are started and stabilized.

[kasiday1 0]

Mode should change from S/CREW ENG START to AFTER ENG START automatically once both engines are started and stabilized.

engines stabilised nothing is happening

[JET 1 0]

Confirm again that once you have the engines started and stabilized, the mode in the Main panel stays at S.CRW/ENG START (in yellow) and will not change to AFT ENG START (in white)?If that is not happening and you don't hear the FO flipping switches during is after start flow, we'll need to wait until Bryan chimes in...

[kasiday1 0]

Confirm again that once you have the engines started and stabilized, the mode in the Main panel stays at S.CRW/ENG START (in yellow) and will not change to AFT ENG START (in white)?If that is not happening and you don't hear the FO flipping switches during is after start flow, we'll need to wait until Bryan chimes in...

confirmedwaiting thx for your concern

[byork 2,259]

confirmedwaiting thx for your concern

Are you starting the engines using the FS2Crew voice commands? "Start the left engine"... "Start the right engine"...?Is pushback in the FS2Crew config panel set to required or not required?Pls advise as the mode should automatically change... but you can always do it manually if need be.Best.