Hello. 1. First time i was flying after installing FS2Crew on Wilco feelThere 737 PIC everything was fine and i love the software! But then the f/o stoped with take off call out. Running "Preflight Checklist", "Before Start Procedure/Checklist", "Pushback", "Taxi", "Before Take Off Checklist" all fine! Then i call "Cleared" f/o does respond. Then i call "Take Off" f/o doesn't respond. I take off and hear no speed check, v1 and rotate. No positive climb as well. I call "Gear Up" and nothing happens. And the display is frozen at Take off/Roll out. F/o Dosn't perform any actions until i scroll checklist panel to "After take off check list" I call it and everything works again all the way to the end.So Take off and climb doesn't work some how.2.Also i heard something about that i have to assign keyboard kommands in Wilco feelThere 737 PIC to work with Fs2Crew. I haven't done it. I couldn't find how to do that anywhere.Can somebody please help me with it?Thank you.Roman.

Hi Roman,Did you install SP1?http://www.fs2crew.com/cart/pages/FS2Crew%3A-737-Voice-Commander-Updates.htmlIf not, please do so.Assigning a key is only required for the 'mute' function if you're using on-line ATC.See this thread on how to assign Mute:http://forum.avsim.net/topic/277586-how-to-assign-mute-button-with-sp1-versions/Best,

Hello Byork.Thank you for your respond! I don't use online ATC and i have installed SP1.Tried to reinstall fs2crew followed by (SP1) but the problem remains. After respond to "cleared" no respond to "Take off" call and no actions on take of roll and climb :(f/o does respond to flaps and sometimes autopilot functions but no gear up. And it doesn't do anything. Display is stuck at (yellow) "Take off roll". I tried everything i can but nothing works.Thank you for your support.Regards.RomanPS. It does read ALL of my commands!

Hello Byork.Thank you for your respond! I don't use online ATC and i have installed SP1.Tried to reinstall fs2crew followed by (SP1) but the problem remains. After respond to "cleared" no respond to "Take off" call and no actions on take of roll and climb :(f/o does respond to flaps and sometimes autopilot functions but no gear up. And it doesn't do anything. Display is stuck at (yellow) "Take off roll". I tried everything i can but nothing works.Thank you for your support.Regards.RomanPS. It does read ALL of my commands!

Hi Roman,You're probably in the wrong Mode.Make sure the Mode in the FS2Crew Window says "Takeoff Roll".Then say "Takeoff".You should get all your calls.

Hi Bryan. The mode is in Takeoff roll and it stay that way after takeoff. The only way i can continue is by scrolling it to after takeoff check list. So it skips takeoff roll and climb. So basically it doesn't work between "takeoff roll" and "after takeoff checklist". I've been through fs2crew manual and training videos. So I'm not doing anything wrong. I'm pretty lost now. Note that it worked at the first flight but never sense.. Any ideas?Thank you for you time!