Ezdok camera issue, please help quickly :)

[MM7 42]

Ok, so when I start my FSX up, my camera is locked at my radio coms panel and I cannot seem to look up at the overhead panel, I only get level to the MCP panel. Please will someone help!

[NGX 1]

This is the PMDG NGX support forum, not the EZDock camera forum. Contact them with your issue.

[pride545 30]

You're kinda RUDE!!!

[MarkW 1,490]

You have probably hit the 3 key (default) and activated the global disable. Go to the menu and enable again. I have actually deleted that shortcut to prevent this from happening in the future. Mark.

[ZKOKQ 984]

You may need to go to addons menu in fsx and select global enable...nevermind, Mark bet me to it :)

[Peter de Bruin 0]

Did you remember to run the Ezdok configuration tool again after installing the NGX?

[MM7 42]

hi Sorry if I came across a bit rude, was in a tiny hurry :) I can move it around if I use the middle mouse button, works fine, global enabled, I just can't look down/up past a certain point.

[ZachLW 37]

I would try the EZ Dok support forum. Lots of info over there. Also make sure you ran EZCA config.exe since a/c install

[jbassue 181]

You're kinda RUDE!!!

Run the Manager!Big help.For my brother at least ;)

[wanabflyer 53]

hi Sorry if I came across a bit rude, was in a tiny hurry :) I can move it around if I use the middle mouse button, works fine, global enabled, I just can't look down/up past a certain point.

I am sure the 'Rude' post wasn't directed at you. Did you get your problem solved?

[jbassue 181]

I am sure the 'Rude' post wasn't directed at you. Did you get your problem solved?

I thought it was for NGX, because she's kind of...

[MM7 42]

:( Unfortunately I cannot find anyone else having this problem

[jbassue 181]

Unfortunately I cannot find anyone else having this problem

Have you tried cycling with the A key?

[738 72]

I had the same issue mate, i then opened up the studio, right clicked a free grey bar under the preset internal cameras and created my own, you do have to select your custom setting when you start a new flight but it done it for me!

[Chrisv007 0]

Holy Cr...p! That's what I forgot to do. Run the configuration tool!!Thanks guys! Will give that ago this evening!