Jump to content

Archived

This topic is now archived and is closed to further replies.

Mimid

Radio Com on 737 NGX

Recommended Posts

I wonder if it is possible to listen two frequencies VHF at the same time. Example: radio operator panel on the left side (VHF1) Com1 on Unicom 122.800 and radio operator panel on the right-hand side, (VHF2) Com2 on a Atis frequency.

Share this post


Link to post
Share on other sites

Yes it possible It's even possible to listen the two frequencies from the same Radio Communication Panel (RCP), push VHF 1 to tune VHF 1 and then push VHF 2 to tune VHF 2. If you push the the VHF 2 on the capt RCP the light between the ACTIVE and STANBY window will illuminate. Then go to the Audio Control Panel to select both VHF 1 and VHF 2 audio selection.


Mark Scheerman

 

Boeing 737-6/7/8/900 Ground Engineer

Share this post


Link to post
Share on other sites

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    45%
    $11,435.00 of $25,000.00 Donate Now
×
×
  • Create New...