Hi,I recently made some own updates to a payware scenery I own, EKCH by Scansim.EKCH has three runways:When the 22 flow is used: Rwy 22R is used for takeoff, Rwy 22L is landing. (04 flow: 04R takeoff, 04L landing)I have made four separate AFCADs to use with the different flows, and for the 22 flow, I have set 22R to CLOSED for landing, but open for takeoff, and vice versa on 22L. But still the dang AI sometimes land on 22R... I thought that it was possible to direct the traffic as to runways for takeoff and landing, as long as it was in one direction (ie. if I made the same thing for Rwys 04R and L in the same AFCAD, it wouldn´t work)But now it still doesn´t seem to work..Any ways to fix this??Kind regards,Johan

Hello Johan,This forum is used for the rare questions on altitude mesh, so you may not get many answers here. Perhaps you could try the Scenery Design forum right above this one where you will probably get more attention.Best regards.Luis

Ooops.. I thought that was where I posted.. Sorry, thanx.