Any help with assigning seperate throttles in FSX with the Saitek Pro with extra levers please?

I am told (after purchasing FSUIPC) you don't need it. I am having problems with the No1 throttle (Next to the Spoiler handle) it only works between half way open and fully open.

Your advise appreciated?

Hey Dave, go to settings-controls-to the third window then pick your saitek pro, and set the second/third engine thrust for your desire. cheers.

If you purchased fsuipc then read the instructions that came with it. It explains separate throttle setup

Hey no name, go to settings-controls-to the third window then pick you saitek pro, and set the second/third engine thrust for your desire. cheers.

Daniel. I'm a little surprised in your response, you always sounded like a good guy to me? My name is within my signature as yours is too.

 

You clearly didn't read my question properly. It is the number one throttle that I am having the problem with and not the second.third engine as your answer refers too.

 

I have calibrated and calibrated again and again and everything works as it should but, not in the sim. I even tried it with a seperate Pro flight yoke throttle.

 

If you purchased fsuipc then read the instructions that came with it. It explains separate throttle setup

Thank you for your help.

Daniel. I'm a little surprised in your response, you always sounded like a good guy to me? My name is within my signature as yours is too.

 

You clearly didn't read my question properly. It is the number one throttle that I am having the problem with and not the second.third engine as your answer refers too.

 

I have calibrated and calibrated again and again and everything works as it should but, not in the sim. I even tried it with a seperate Pro flight yoke throttle.

 

Hey Dave, i clearly didn't see your name so i am sorry for that matter, it's my bad. for your problem, i have experienced that, did you acutally try the freeware fsuipc? or reinstall or to back everything to default that's worked for me. cheers mate.

Check from the controll setup that null zone is at 0 and sensitivy or what is the other one is full. You can find it from the controll setup first page and you need to pick up saitek throttle and press "advanced".

Well I have spent the last 3 hours reading through them and trying to follow the FSUIPC pdf's and I am at square one.

Well I have spent the last 3 hours reading through them and trying to follow the FSUIPC pdf's and I am at square one.

good luck Dave.

Check the null zones in fsx, if all looks good, start fsuipc.

 

Go into calibrations, hit scan and move ALL the levers in your throttle quadrant, one by one, after moving each one, assign what it will be used for, ie spoiler, throttle 1 or 2, etc.

 

Then without exiting go into the assignments tab and assign the levers to the respective engine or spoiler, then hit ok and test.

 

See how you go.

 

Check the null zones in fsx, if all looks good, start fsuipc.

 

Go into calibrations, hit scan and move ALL the levers in your throttle quadrant, one by one, after moving each one, assign what it will be used for, ie spoiler, throttle 1 or 2, etc.

 

Then without exiting go into the assignments tab and assign the levers to the respective engine or spoiler, then hit ok and test.

 

See how you go.

Your advice worked for me. Thankyou so much.

Pleasure, glad i could be of help.