Jump to content

Archived

This topic is now archived and is closed to further replies.

Arz2934

Panel does not load up properly after reloading the aircraft

Recommended Posts

Hi, I just started using the 747-400X and all is fine, but I have just one issue. I can load a flight and fly from point A to point B perfectly, but if I end the simulation and restart it with the 747 even with a different livery, engine type or at a different airport, my panel on the captain's side is completely black and on the first officers side there are some weird warnings in yellow but the attitude indicator on the PFD is not visible. Also my overhead panel is not like how it should be (See uploaded pictures). This isn't too much of a bother because all I have to do is restart FSX but I'd rather have the problem taken care of.


Armaan Kantemborn

Share this post


Link to post
Share on other sites

The whole "reloading the aircraft" is where I think the issue lies. Make sure you're saving the panel state when you save a flight.

 

Also, I don't think it's good for the sim to reload the same complex add on on top of itself (even a different livery is still the same complex add-on).


Kyle Rodgers

Share this post


Link to post
Share on other sites

As kyle as said after your first flight you cant reload again with a different livery one of those fsx bugs that effects some pmdg aircrafts. If you read your introduction manual on page 16 it refers to saving your panel state


I7-800k,Corsair h1101 cooler ,Asus Strix Gaming Intel Z370 S11 motherboard, Corsair 32gb ramDD4,    2  ssd 500gb 970 drive, gtx 1080ti Card,  RM850 power supply

 

Peter kelberg

Share this post


Link to post
Share on other sites

×
×
  • Create New...