Jump to content

Archived

This topic is now archived and is closed to further replies.

Stelios

FSBuild and ILS approach

Recommended Posts

I have generated so far 2-3 flight plans with FSBuild (including SID/STAR as well as TOC/TOD) and import them into FMC of the 737NGX. Everything goes OK but when I arrive at the destination airport it never takes me to intercept the ILS of the generated runway. Am I doing something wrong? I was under the impression that FSBulid will take m to the generated runway.

 

 

and just another point in the Legs section, when the waypoint turns pink (magenta) do I adjust then the altitude shown on the right?

 

stelios


Stelios Christofides

Share this post


Link to post
Share on other sites

This is because the NGX does not use the saved SIDs/STARs. You have to manually put them in when you're doing your flight prep. There is a post about it by Tabs somwehere around.

 

Hope this helps


Richie Lumsden

Share this post


Link to post
Share on other sites

×
×
  • Create New...