TOGA and reverse on Satitek throttle?

[GodAtum 69]

How do I assign these functions? I want the TOGA to be on one of the throttle buttons and reverse to be on another. i tried using the PMDG keyboard menu but the button clicks wont register.

[eurowing 13]

i don't think you can assign a button to the go-around switch. (you probably can if you have the full fsuipc version, though; not sure)

 

for the reverse thrust, you need to assign one of the levers bottom range (below idle) as a button to the decrease throttle function (same as default F2 assignment on keyboard). that way when you go to idle and move the throttle lower past the detent it will go into reverse. that's how i have it set up. to go back to idle after that you will have to give it a little power again.

[Mavrick11 3]

How do I assign these functions? I want the TOGA to be on one of the throttle buttons and reverse to be on another. i tried using the PMDG keyboard menu but the button clicks wont register.

 

I have the same setup as you have. What I did was in FSX button setup, I scroaled down to where it said reduce throttle quickly which the keyboard command is F2, I then asgned the lever of my choice on the Saitek throttle by pulling the lever all the way down for the reverser. This will work for the reverser, I can't help you on the TOGA question.

 

Les H :hi:

[GodAtum 69]

Thanks I also had to check the repeat function too.

[eurowing 13]

oh true, i forgot...