Jump to content

Archived

This topic is now archived and is closed to further replies.

slk1

Loss of use of the mouse only in the VC of the 737NGX

Recommended Posts

Hi - has anyone any idea as to why the mouse would stop turning the knobs ect  in the VC -only from the view from the Captains seat - of the 737NGX? The mouse retains movement but is non fuctional in this view. The mouse works in any other view in the VC. I use EZDOK camera. Any help or suggestions would be much appreciated.

Thanks Shaun Keegan

Share this post


Link to post
Share on other sites

I sometimes get the same problem, and EZDok seems to be at the root of it. Try pressing 2 on your number pad, followed by a minor adjustment of your viewpoint (perhaps zoom out or in, then put it back where it was), then press 2 again to re-save the camera. That usually works for me. When it doesn't, I just delete the offending camera and start again.


Regards,

PD

Share this post


Link to post
Share on other sites

I don't use EZDok (any more), but I noticed that the mouse stops working if you zoom out too far. Try a higher zoom value for this specific view.


Stefan Keller
ngxu_banner.png                 

ugcx_banner.png

Share this post


Link to post
Share on other sites

Hi - has anyone any idea as to why the mouse would stop turning the knobs ect  in the VC -only from the view from the Captains seat - of the 737NGX? The mouse retains movement but is non fuctional in this view. The mouse works in any other view in the VC. I use EZDOK camera. Any help or suggestions would be much appreciated.

Thanks Shaun Keegan

Shaun - it happens to me also. ....and I haven't got EZDOK. Never had it.

 

The mouse functions normally re-appear after a short while. Can't seem to pin it down.

Quite annoying.

 

Regards

Bill


i7-3770K 4.2GHz, 16GB, GTX 970 4GB, Win 7 64bit, LG 38GL950G, CH Yoke/Pedals, T.16000M, GenX UK, UK2000 EGGP & EGCC, AeroSoft Gibraltar, FSC 9.5, FSL A320X, 737NGX A318/A319/A320/A321, A2A Cherokee/JF Hawk T1/Dino's EF2000, Iris Grob Tutor
 

 

Share this post


Link to post
Share on other sites

If the users viewpoint is inside any of the cockpit geometry (such as the seat or headrest behind the user) then the VC clickspots will not work, as technically you are no longer inside the VC as far as FSX is concerned. Move the viewpoint slightly forward and you will likely find that it starts working again.


Cheers, Andy.

Share this post


Link to post
Share on other sites

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    21%
    $5,415.00 of $25,000.00 Donate Now
×
×
  • Create New...