No Clearance to Land v.1.16

[jimgem 0]

I recently upgraded to v. 1.16.  Everything seemed to be working well, but during my last several flights the program would not issue a landing clearance.  The program issues all the necessary approach vectors and instructs the first officer (operating radios) to contact the arrival airport tower.  The tower is contacted indicating that the aircraft is on approach for the assigned runway.  The tower responds to this communication, but no landing clearance (or any other communication) is issued after this point.  I ran the indexer a couple of times but with no effect.  The odd thing is that sometimes I get a landing clearance and sometimes I don't.  Recently, I have not been getting a landing clearance.

 

Has anyone else experience this issue?  Did I forget to complete something in the setup?  Any ideas?

 

 

[Tallguy 9]

There is no v1.16. You probably meant v6.16.

[jimgem 0]

Of course it's v.6.16. I just wanted to be sure that you guys were paying attention.

[cbd80 3]

Hi. I have encountered this problem before, but it has been rare so far with v6.16.

 

The developer is aware of the issue and hopes to get the fix into the next update.

 

In the meantime I quote his solution below:

 

"a workaraound for the moment is to disable VoxATC after you have contacted the center controller and then enable it again, contact center and continue the flight."

 

I hope that is of some help to you.

[Tony P 160]

+1 happens to me on a regular basis.  However,  sometimes if I initiate the contact with tower by saying... ## tower,  Cactus 463 with you at flight level two thousand seven hunderd - then I get cleared to land.  Not every time though...hope this is corrected soon.