Trouble with VRI MCP2 and LINDA - No response

[PilotRob 0]

Hi 

 

I have just tried setting up my new MCP2 panel with LINDA with no joy

 

LINDA has been handling my yoke for several weeks and is working fine.  I have attached my panel, followed the install instructions (VRiSim then MCP panel installer).

I have followed the LINDA instructions (COM3, etc) and LINDA reports all is OK.

When I start FSX (or hit "Reload LUA Engine" my panel reachs, displays "LINDA Init..." and then says "ready"

 

The problem is ' there is no further interaction between the panel and LINDA, the LINDA UI does not respond when I press panel buttons, the panel has not updated the mode labels and the panel buttons do not affect the aircraft as per the LINDA setup.

 

Any ideas what I'm doing wrong?

 

Cheers

 

Rob

[UAL066 0]

Have you started either the APU or engines?

[PilotRob 0]

Have you started either the APU or engines?

Yes, no effect!

Like I said, the "LINDA Init" appeared on the panel as I loaded the aircraft but no response after that