Awful Runway Lights

[burm 3]

Since I installed the fixer a month ago flying during the day is good.

Flying at night in and out of airports, the runway lights are pretty bad.

I use mostly large payware airports.

Is there any way to fix this?

Paul

[SteveFx 258]

Pretty bad in what sense?

 

Are they airports that previously were grey at night or not? What happens if you uninstall the libraries and try in default dx10?

 

If you are referring to legacy airports where the lights go out at certain viewing angles then that can be addressed using a light field bgl as described in the manual.

 

If the lights are too bright perhaps the try disabling bloom and reducing the bloom lights slider in dx10controller

[burm 3]

I am referring to the lights on the runways that one follows when taxiing.

they appear as a pyramid shaped cone.

I always fly to and from large payware airports.

I also use REX weather.

I will try what you suggested.

Thanks

Paul

[SteveFx 258]

Hi Paul, can you list some examples of the airports.

 

For solid light cones I would suggest

 

check that the 8 bit fix is unticked this "fix" is only intended for testing legacy aircraft it should never be left set on

 

if that's ok then move the legacy slider to the left

[Jude Bradley 659]

Hello Steve,

YSSY (Flytampa)

[SteveFx 258]

George at fly Tampa suggested you reinstall the airport did you try that?

[Jude Bradley 659]

Hello Steve, will try later today
 

[Jude Bradley 659]

Works now, Thanks