Sign in to follow this  

Elite Flight Controls and Avionics Interface for X-Plane 10

Recommended Posts

We are pleased to announce the release of our Elite Hardware Interface for X-Plane 10.


This product allows you to use Elite Flight Controls and Avionics with X-Plane 10.20 or greater in 32bit and 64bit mode. There is nothing to assign, no buttons, switches etc. Everything is pre-configured. You can change the sensitivity of all flight controls to match your preference.


The following Elite Hardware is supported:

  • Elite Pro Panel II
  • Elite Pro Panel SE
  • Elite Standalone Throttle Quadrant (Multi or Single Engine and King Air)
  • Elite Rudder Panels
  • Elite AP4000 Avionics Stack
  • Elite AP3000 Avionics Stack (Apollo GPS not supported)
  • Elite COM/NAV Radio (2 modules supported for COM/NAV1 and COM/NAV2)
  • Elite ADF Radio Module
  • Elite DME Radio Module
  • Elite Auto Pilot Module
  • Elite Altitude Pre-Select and Audio Panel Module
  • Elite Transponder Module
  • Elite NAV/CRS/HDG Module
  • Elite GNS430 Module
  • Elite GNS530 Module 
    (2 GPS modules supported for X-Plane GPS only)



IMPORTANT! This software only supports Elite Devices with a USB Interface. 
Serial Devices (RS232) are NOT supported, even when used with a serial to USB converter!


For more information, visit our product page.

Share this post

Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

This topic is now closed to further replies.
Sign in to follow this