Hi Guys, 

 

 

Please can you help me i had just installed aerosoft airbus X extended on Prepar3d v2.2 .  When i run the Simulator i found out the ND display is blank not shown  so please can you help how to overcome with this issue. Fast reply from you would be highly appreciated. 

 

Best Regards

Thank you 

On the right mcdu set the aircraft state to cold and dark, then switch on the batteries and set the aircraft state to your desired setting (if not c&d). I find this happens if you don't set to c&d first in p3dv2.2.

On the left of the panel you will see some dials. Use these to adjust the brightness of the displays.