Voice: setting standby comm1 and swapping

[tjeuten 6]

Hey,

 

according to the manual, using voice we should be able to command "set xxx.xx on standby comm 1" and then later "swap comm 1", as in the NGX.

 

However I cannot seem to do so, the FO doesn't understand "standby", and neither does he understand "swap comm1".

 

The only thing that seems to work is "set xxx.xx on comm1", which sets comm1 directly without using the standy frequency.

 

Is this a bug or is this due to my system (works perfectly with the NGX) ?

 

Thanks

[jordanal 70]

I'm pretty sure I noticed the same results recently - using latest v1.1.

[byork 2,259]

Is swapping in the list of available commands in the 777?

[tjeuten 6]

Don't think it says it explicitely, but setting on the standy frequency is available as stated in the manual, so I assume swapping should be too...

 

But setting on standby doesn't work either

[byork 2,259]

 

 

Don't think it says it explicitely, but setting on the standy frequency is available as stated in the manual, so I assume swapping should be too...
 
But setting on standby doesn't work either

 

 

I'll check it for V1.2.

 

Cheers,