Saitek X52 overriding Altitude Hold

[themaster402 0]

I have recently bought a Saitek X52. The variety of controls is amazing. One of the control wheels, what I call the E control wheel, is set to Elevator Trim. It makes it easier to set trim for takeoff, but when I set the autopilot and altitude hold, the plane continues to pitch up. I check on the elevator trim and it is stuck at 5 degrees. Anyone know how to fix this?

[untoweechja 35]

The first thing I'd suggest is to make sure you have the sensitivity on the E control wheel maxed out in the FSX controller configuration.  

 

Instead of using an axis wheel for the trim, I have the elevator trim up (Num 1 by default) and elevator trim down (Num 7 by default) mapped to the hat switch on the throttle.  I've found this gives me much more precise control over the trim and allows the autopilot to adjust the trim as it needs to without any interference.

 

I've also got the rudder trim mapped to the left and right buttons on the same hat, so all of the necessary trim controls are under one finger.

[AVSIM Admin 4]

This is an automatic message.

 

This topic has been moved from "MS FSX Forum" to "Hardware Controllers & Drivers". This move has been done for a number of possible reasons.

• The most likely reason is that the post was off topic.
• The topic could also have contained images or a video that were not appropriate to the original forum it was posted in.
• The images might not have been "illustrative" or "explanatory" in nature.
• The topic could have been moved because we deemed it to be more appropriately placed elsewhere.

Please ensure that your posts are "on topic" and contain illustrative images or videos as appropriate. Do not post videos or images just for entertainment purposes anywhere but in the screen shot or video forums. See our image posting rules here.

 

Members who continue to post off topic posts can be denied entry to specific forums in order to reduce and remove the practice. Your cooperation is appreciated.