Ok ScottFlieger,

 

Many thanks for your patient en support untill now.

Everything works so far.

 

The next step is the VRInsight FCU combo.

(I am searching for one at a reasonable price. Maybe second hand/used)

Hello, I am there again,

 

I have set up my thrustlevers with FSUIPC and everything works (nearly)

 

When I move the levers for the first couple of mm the thrust is immediatly rising to 60%. Very annoying when you will to taxi and drive for abt 40/50 km on the taxiway :-)

Is there a way to finetune the levers so that I can move the levers smoothly.....

Hi LionAir

 

You need to calibrate the throttle axis after assigning it. Click on the Calibrate Axis tab and use arrows to find the Throttle page (2?).  Click reset in Throttle pane, then set.  Move throttle to minimal and click Set above -16000? value. Then move throttle to max and click set above +16000. If you still have the problem make sure that no axis is assigned to Throttle in FSX/P3D settings.

Hi ScottFlieger I have tried that but afterwards my throttles are not moving anymore att all....

 

I use throttle 1 and 2.

I have set the throttle axis count also set to two in the Airbus Configuration..

 

Any idea.....??

Hi LionAir

 

The Aerosoft Airbus only uses a single Throttle operating both levers. Clear Throttles 1 and 2 and set only Throttle in FSUIPC.

Hi ScottFlieger,

 

I have tried this but the (single/middle) lever jumps from idle direct to A/THR without smooth in between

 

in Airbus configurator - chosen 1

I have assign it at the Axis assignment tab

calibrate it on the joystick calibration tab as you described

 

Further more, is it not strange that you can choose in the Airbus configurator for 2 engines, when it does not work??

 

Hope you have still more ideas/solution to try for me...

 

thanks