oom

[luckynic1 0]

Hi guy's hope everyone is well.

Just went to do a flight from cyyz fly tampa to tfff.

Sitting at the gate in the 777-200 no more than 10 minutes did all the pre checks and programming the fmc.

Started to get the dong noise in the background by the time i had pushed back and started to taxi i got the oom warning.

Ok try again 737ngx same gate done pre checks and fmc prog push back and taxi to holding point no probs at all.

Went back to the 777 again this time the 300 did the pre checks and fmc same thing again oom.

also went to a few more airports kjfk fs dreamteam  egll aerosofts lax ksfo etc all got the oom warning.

Think it maybe time for a formatt unless you guy's have a susgestion

also have tried Dave susgested setting in fsx asn and few other things he mention

Guy's i'm away for the week so a thank you in advance

cheers mark B)

 

[pcubine 143]

Think it maybe time for a formatt unless you guy's have a susgestion

Look at pages 30 thru 34 of the 777 Introduction Manual and post #1 of this thread - http://forum.avsim.net/topic/462838-a-guide-to-getting-the-most-out-of-the-pmdg-777/. Follow the link provided and consider disabling the exterior model. Maybe some of this information might be useful.

[Ed van de Vijver 2]

I had the same problems with Fly Tampa EKCH, after trying a lot of things that didn't work, I changed the textures (under Options) to 512 and the OOM didn't occur after that. To my surprise I didn't notice any loss of image quality.

 

Hope this helps you.

[Don t moderate me this way 882]

Knowing I have a high VAS overhead from tons of photoscenery installed, deactivating the PS usually is enough to get my VAS usage down.

 

One could also try disabling sound preloading (may or may not lead to lagging sounds), and disabling the FS2Crew RAAS (which I always keep active for the added immersion).

[Nyxx 6,993]

Have a read of the guide in my sig