fsx-se HELP-Elevator Trim Problem

[STUART_H 12]

Have recently reinstalled FSX:SE, but seem to have a problem with all planes where the Elevator Trim is trimming down all the time, it doesn't stop until it reaches max down trim. Trying to reset it back to normal takeoff condition and it just starts dropping down again.  Have never seen this before in all my years using FSX !  Has anyone else experienced this or can point me to what the problem may be?

 

I have my Joystick controls disabled in FSX Control Settings and reset and calibrated using FSUIPC, but no matter what I seem to do, the Trim/Trim Wheel constantly moves down until it reaches the limit then stops. Trying to move back has no effect as it just moves back to max down trim on its own.

 

This happens in all planes from default cessna to the majestic Q400.  I am at my wits end as to what could cause this.

 

Stuart

[JSkorna 137]

Autopilot On?

[frieone 37]

Yes that has happened to me.

look in the configuration file for

a line that says auto trim change to false

 

Regards ted kiser

[STUART_H 12]

I don't think the auto pilot is on as the cockpits are 'cold & dark'.

 

Ted, which config file are you referring to, FSX.cfg? Was not aware of such an entry.

 

Stuart

[charliearon 3,024]

in your FSX.cfg

 

 

[REALISM]
PFactor=1.000000
Torque=1.000000
GyroEffect=0.990000
CrashTolerance=1.000000
General=1.000000
UnlimitedFuel=False
TrueAirspeed=False
AutoCoord=True
RealMixture=True
StressDamage=True
GEffect=True
ManualLights=True
GyroDrift=True
CrashWithDyn=False
CrashDetection=True
AutoTrim=False
 

[STUART_H 12]

Thanks Guys,

Went and investigated again, and although AutoTrim was already set to false, I then noticed that the Autopilot was in fact set to on. After turning it off all is fine again.

You were right Jim.

Yeah!

Thanks again,

Stuart