Jump to content

Sign in to follow this  
davemb60

Plane drops suddenly on runway during an ILS landing

Recommended Posts

Hello,

 

I have a question for the pros.  During an ILS landing using my PMDG 737 at 100 feet above the touch down zone on the runway my plane suddenly drops onto the runway.

Any clues as to why this is happening?

 

Thank you,

Dave

Share this post


Link to post

I suspect sometimes when cpu is too busy fs skips positions like any other game.

 

One way to avoid such in future lower your graphic settings, or upgrade  cpu/gpu keep current eye candy.

 

I have noticed recently that turbulence  especially in GA is a lot more realistic when I keep graphic sliders low, again its the skipping of positions thing happening in turbulence.  

 

Also maybe worth running latest makerwys , in case its scenery issue, scenery experts can advice better on that.

Share this post


Link to post

Do you have your airspeed set at what the FMC says it should be for the landing? 


PF3 Beta Tester

Bob Cardone        P3D 3,4       FlyVirtual.net   Aivlasoft EFB2  /pf3-supporter.gif

 

 

 

Share this post


Link to post

First ever post by the OP, and in writing the question seemed to have adequate knowledge to answer the question without asking.

 

So my responses: 

Did you run out of fuel?

Did you forget to adjust your altimeter and your weather engine refreshed?

Were you approaching a sloped runway?

Did your payload shift forward for some reason?

Did you take a restroom break without pausing?

Did you approach too near and underneath a heavy transport and encounter wake turbulence?

Did you err and attempt an approach during a thunderstorm and encounter a microburst?

-or-

Did you neglect to listen to ATIS and subsequenly hit the B key on your keyboard?


Frank Patton

Gigabyte GA-Z97X-Gaming 7 MOB; i7 4790 4.4Ghz; 16gb DDR3 2300; MSI GTX970 4gb Gaming 100ME, ASUS GTX 1070 TI Turbo 8GB, Coolermaster Pro 5 case, Corsair H100i

Former USAF meteorologist and ground weather school instructor; AOPA Member #07379126

There is no limit to what a man can do or where he can go if he doesn’t mind who gets the credit! - Benjamin Jowett

 

Share this post


Link to post

I don't think anyone here understood what you asked, but i am gone take stab at this as i had same issues this occurs with mesh settings, if ur mesh is set to high, it could cause issues on some airports where on final approach u literally land on invisible runway and suddenly find your plane on runway.  make changes to the settings and try again.  good luck, recommend setting it to 5 meters.

 

good luck

 

 

Hello,

 

I have a question for the pros.  During an ILS landing using my PMDG 737 at 100 feet above the touch down zone on the runway my plane suddenly drops onto the runway.

Any clues as to why this is happening?

 

Thank you,

Dave


Andre Malishkin

 

- I am not a real pilot, but i did stay at holiday inn express -

Share this post


Link to post

Hi all,

 

Had the same issue several times flying PMDG NGX, especially on short rwys (i.e. LICJ Italy and PHOG Hawaii). Ended up disabling crash detection to avoid flight reset. I'll give a try to the mesh settings tip, thank you so much amalishkin.


Massimo Burti

 

Boeing777_Banner_Pilot.jpg   24.jpg

 

i7 4790K 4.00GHz ¦ Asus Z97-Deluxe ¦ Kingston HyperX Savage DDR3-2133 16GB ¦ Asus GTX 1080-8G Founders Edition ¦ ASUS ROG Swift PG278Q Gsync ¦ Win10 Pro on Samsung 850 Evo, 500GB ¦ P3D on Samsung 850 Evo, 1TB¦ CH Eclipse Yoke ¦ Corsair K70 RGB Cherry MX Red

Share this post


Link to post

As Andre suggested, this sounds like a scenery issue.  You can test this by trying several airports.

 

Mike


 

                    bUmq4nJ.jpg?2

 

Share this post


Link to post

Hi Everyone,

 

Thanks for the responses.  I think I will try the mesh approach and crash detection.

I tried different airports. Specifically KSFO from FSDT.  Worked perfectly.

I will try a few other stock P3D airports.

 

Thanks,

Dave

Share this post


Link to post

I tried the mesh setting at 5m and that fixed the problem with the sudden drop on rwy 27 at KBOS. Thank you Amalishkin.

(Can't wait for some KBOS airport scenery to come out, I think FlyTampa is working on a reboot for KBOS)

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    22%
    $5,550.00 of $25,000.00 Donate Now
×
×
  • Create New...