fsx-ms FSDT KLAX (AI Aircraft) Has a fix been found?

[castarr 0]

I have read thru all of the forum discussions on the FSDT forum page..about the Stuck AI that occurs at KLAX..seems every other aircraft is instructed to line up and wait..however

the FSX ATC seems to award clearance for the first aircraft but not the second..in line..it sits and times out!...HAS a FIX been discovered..?

 

This may be old news...but i just recently purchased this scenery..to add to my KDFW  and KORD...

 

but right now...it's a headache and painful to watch...an aircraft...vanish into oblivion!

 

Suggestions already included...HOLD and START nodes..that came with scenery..closer to runway..etc..but that doesn't work..either..

 

Your input welcome,

 

Regards,

Chris

 

 

 

 

[Dave_YVR 973]

 I can only suggest to use a different afcad, I don't use a stock one from FSDT and my AI has never had this problem. I'll go test the latest default right now and then test it again once I adjust a couple things.

[Dave_YVR 973]

 Well that wasn't too hard at all. Using the default afcad, the AI line up and are NOT cleared for take off. I spent 3 minutes to widen the runways, as suggested in the FSDT forums and also added one missing hold short node at the end of 06R. AI and user aircraft now line and and take off as they should. I watched a few dozen AI depart both 06R and 07L without fail.

[castarr 0]

Super..idea...let me go in....and piddle..with a short node.....on these runways...i'll report back...

 

many many thanks, Dave..(cross your fingers)! :-)

 

Regards,

Chris

[castarr 0]

I used the ADE to place hold short node (red dot) at all the runways of FSDT KLAX...tested the scenery....all ai flights and my own aircraft i was flying were cleared for takeoff...!!

 

"Whew"!!! nice work-around"...

 

 

I'll keep looking at it...to see if any other issues pop-up...but for now..this post is  answered

 

Thank you, Dave!

 

Regards,

Chris

[Dave_YVR 973]

 That's great to hear Chris!

 It's not so much a work around but just giving the sim what it needs to function correctly. Also keep in mind that ALL of the hold shorts were already in place except the one at the far west end of 06R.