aerosoft twin otter

[N1G 88]

Anyone using this with p3dv3?

 

Bob

[kevinfirth 1,392]

Tested it briefly yesterday with 3.2, seemed like it worked fine, inc wave action in ultra water...

[N1G 88]

Tested it briefly yesterday with 3.2, seemed like it worked fine, inc wave action in ultra water...

Tested it briefly yesterday with 3.2, seemed like it worked fine, inc wave action in ultra water...

Thanks Kevin, did you have to modify the installer or did aerosoft create a v3 install?

 

Bob

[kevinfirth 1,392]

no didnt need anything doing at all, I originally installed it in 3.0 and made no changes to it whatsoever

[N1G 88]

Thanks Kevin, I could not find anything out about it on aerosoft. Like pulling teeth with some, but not all!

 

Bob

Kevin, here is a post from another simmer having issues with the install in February of 16

http://forum.aerosoft.com/index.php?/topic/105159-twin-otter-extended-work-in-v31/

 

I was wondering if, depending on the vendor, could the installer be different?

 

Thanks

Bob

[kevinfirth 1,392]

Bob, I doubt the installer is different, its impossible to tell from the info in that thread what the OPs problem was. Just install it, point at P3D3.2 folder....

[N1G 88]

Bob, I doubt the installer is different, its impossible to tell from the info in that thread what the OPs problem was. Just install it, point at P3D3.2 folder....

Thanks Kevin, I did not think there would be a different installer either. Anyway, breaking open the wallet.

 

Bob

[Guest]

Per Kevin, Twotter works very well in P3D V3.x ... no need for EMT.

 

Cheers, Rob.

[steve howlett 137]

Only thing i noticed is that the rear two wheels don't turn when it's moving.front one is fine.

doesn't make any difference unless you view the Otter from spot of tower view.

mind you...could be just my version.interested to see if anyone else has same problem.install version is 1.11

 

 steve