Jump to content
Sign in to follow this  
Followers 0
crosswind

PREPAR3D v3.2 PATCH

By crosswind, in MS FSX | FSX-SE Forum

Recommended Posts

crosswind    825

crosswind
Posted

No

KROSWYND    a.k.a KILO_WHISKEY
Majestic Software Development/Support
Banner_MJC8.png

Sys 1:  AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2:  i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware:  Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM grip
SIMULATORS: MSFS2020/XP12/P3D v5.4 & v6:  YouTube Videos

Share this post

Link to post
Share on other sites

crosswind    825

crosswind
Posted

Correct - it is an incomplete file and can result in  abnormalities as that is a test file

KROSWYND    a.k.a KILO_WHISKEY
Majestic Software Development/Support
Banner_MJC8.png

Sys 1:  AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2:  i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware:  Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM grip
SIMULATORS: MSFS2020/XP12/P3D v5.4 & v6:  YouTube Videos

Share this post

Link to post
Share on other sites

Yogipriester    11

Yogipriester
Posted

Just downloaded and installed(copied) it as I was very curious and could not wait.

 

Now doing a small test ride from DNMM to DGAA on IVAO:

 

1. It took a very long time before the "GEN warn" disappeared and the "GEN On" came up. Perhaps that is the reason why the 2nd engine was only starting when I tried it again after the first failure?

 

2. During flight the flickering "Start Starter" and the oscillating APU Fuel Valve Lights are still there as they were in b2.

 

 

Apart from the above I have not seen any other faults but also no improvement either as compared to the b2 version.

Jürgen Martens, DK7HN

Share this post

Link to post
Share on other sites

crosswind    825

crosswind
Posted

Not sure if you were expecting a response.....Incomplete, meant incomplete :)

KROSWYND    a.k.a KILO_WHISKEY
Majestic Software Development/Support
Banner_MJC8.png

Sys 1:  AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2:  i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware:  Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM grip
SIMULATORS: MSFS2020/XP12/P3D v5.4 & v6:  YouTube Videos

Share this post

Link to post
Share on other sites

Yogipriester    11

Yogipriester
Posted

No I did not.

 

However, I just now downloaded and installed the new c-version and all what I observed in my post #20 pertaining to the "incomplete version" holds true for the correct version as well :nea:

Jürgen Martens, DK7HN

Share this post

Link to post
Share on other sites

Yogipriester    11

Yogipriester
Posted

 

 

 

1. It took a very long time before the "GEN warn" disappeared and the "GEN On" came up. Perhaps that is the reason why the 2nd engine was only starting when I tried it again after the first failure?

 

This "fault" is solved. When loading the Q400 with the c-version installed the ground supply is connected. So unless the "External Power" is switched off, the APU Gen will not work properly.

 

I should have looked first :fool:

Jürgen Martens, DK7HN

Share this post

Link to post
Share on other sites

crosswind    825

crosswind
Posted

@Yogipriester

Good to know that you caught it.

KROSWYND    a.k.a KILO_WHISKEY
Majestic Software Development/Support
Banner_MJC8.png

Sys 1:  AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2:  i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware:  Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM grip
SIMULATORS: MSFS2020/XP12/P3D v5.4 & v6:  YouTube Videos

Share this post

Link to post
Share on other sites

regis9    3,999

regis9
Posted

Has anyone found that installing this latest patch and/or moving to P3D v3.2 has made their 125Hz controls non-functional?  Mine have stopped working.

Dave

Current System (Running at 4k): ASUS ROG STRIX X670E-F, Ryzen 7800X3D, RTX 4080, 55" Samsung Q80T, 32GB DDR5 6000 RAM, EVGA CLC 280mm AIO Cooler, HP Reverb G2, Brunner CLS-E NG Yoke, Thrustmaster Warthog HOTAS & Stick, Thrustmaster TCA Quadrant & Add-on, VirtualFly Ruddo+, TQ6+ and Yoko+, GoFlight MCP-PRO and EFIS, Skalarki FCU and MCDU

Share this post

Link to post
Share on other sites

regis9    3,999

regis9
Posted

Disregard, it was a user error by me.

Dave

Current System (Running at 4k): ASUS ROG STRIX X670E-F, Ryzen 7800X3D, RTX 4080, 55" Samsung Q80T, 32GB DDR5 6000 RAM, EVGA CLC 280mm AIO Cooler, HP Reverb G2, Brunner CLS-E NG Yoke, Thrustmaster Warthog HOTAS & Stick, Thrustmaster TCA Quadrant & Add-on, VirtualFly Ruddo+, TQ6+ and Yoko+, GoFlight MCP-PRO and EFIS, Skalarki FCU and MCDU

Share this post

Link to post
Share on other sites

Yogipriester    11

Yogipriester
Posted

 

Good to know that you caught it.

 

So only the flickering APU lights remain. Apparently this does not cause any harm but go on my nerves as long as I dont know what is going on :wink:

Jürgen Martens, DK7HN

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0
Go To Topic Listing

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...