Flight1 Trainer (GTN750)

[N1G 88]

Hi, I am loving the 750 so much. So easy to navigate. Anyway, I was poking around and noticed that the Trainer app is running only on core 3 of my

4 core processor. I moved it to all cores just messing around and did not see any difference, but mostly curious the programmers choice to forc

the app onto 1 core and why core 3? Anyone have any input on this?

 

Thanks

Bob

[GHarrall 494]

In the configuration program you can choose which core to run the trainer on. By default it's set on auto but you can specify if you prefer. It's not recommended to run on all cores.

[N1G 88]

In the configuration program you can choose which core to run the trainer on. By default it's set on auto but you can specify if you prefer. It's not recommended to run on all cores.

Never looked at the config program. Well, they chose core 3, but that might be good for FSX or P3D not sure. I will see if anyone else chimes in and offers how they use it.

Thanks!

 

Bob

[GHarrall 494]

Never looked at the config program. Well, they chose core 3, but that might be good for FSX or P3D not sure. I will see if anyone else chimes in and offers how they use it.Thanks!Bob

I always have mine set on the last physical core.

[N1G 88]

I always have mine set on the last physical core.

Well, I guess I could test all the cores and right down every little detail and post it but........... nah LOL, I will use core 3

 

Bob

[jimcarrel 688]

When it is set on the "wrong" core, it will be obvious. If you notice no problems, then don't worry about it.