T7 mid flight freeze

[Beardyman 604]

Hi,

 

I was wondering if i should submit ticket, but before that i try this forum.

The case is that T7 is freezing every time when during flight i change some P3D settings which require to load again some data.

Then progress bar is coming to some % number ( different every time ) and then stops.

Whole P3D is still running, i can press ESC button and choose some option, but T7 will not load anymore.

Then the only option is to close P3D.

I have checked that few times, it is not single case. 

( i have latest P3D version )

[scandinavian13 5,192]

 

 

The case is that T7 is freezing every time when during flight i change some P3D settings which require to load again some data.

 

Sounds like you're adjusting settings that are reloading the aircraft. As noted in the Intro Manual, reloading the aircraft can cause issues. Make your adjustments without loading one of our aircraft and then save those settings.

[Beardyman 604]

Hi Kyle,

 

I'm not a specialist but it looks like some P3D data is loaded again, not T7.

Progress bar stops when P3D is loading "terrain data" which is not a part of T7 i believe.

[scandinavian13 5,192]

 

 

I'm not a specialist but it looks like some P3D data is loaded again, not T7.

 

Artur,

 

Looks are not all what's actually going on. If the sim environment is loading over, one can be relatively sure that the aircraft is going to be loaded at some point in that process. Try what I offered up in the last post (make your changes while not using our aircraft) and see how it goes.

[Beardyman 604]

Ok Kyle, thanks for support.

[nealmac 260]

Complete shot in the dark here, as I had a similar issue.

 

Do you use FSUIPC, and if so do you have the autosave feature enabled? It took me a while to figure out the problem, but disabling the autosave fixed it for me.

[Beardyman 604]

Hi Neal,

 

I do not have full version of FSUIPC, only freeware.

[nealmac 260]

No worries. Just thought I'd through it out there anyway.