Problems with saitek yoke and the extra quadrant

[rwy12 16]

Hi everyone

Few days ago I bought the saitek yoke set and an extra quadrant.

I plugged the yoke in a usb  power hub and connected the 2 quadrants to the yoke.

I have installed the latest drivers from saitek web.

On the 1st startup everything worked ok.

 

The next day ,

The yoke's X Y axis have stopped working-all the buttons work.

The extra quadrant is not recognised by windows and hence p3dv3.5.

 

I have switched usb ports-even plugged in directly to pc port.

 

The green light come on ,on the quadrant that comes with yoke.

On the extra quadrant,it comes on for few seconds and goes out.

 

I am running   p3dv3.5 on windows 10,64bit.

 

I was hoping to set up the 2 quadrants for jets.

 

I am not sure where I am going wrong-I would be grateful for any solution please.

 

Many thanks.

 

Qas

 

 

 

[kaspern83 77]

i had the same issue with seitek yoke, try removing the saitek drivers and only use the windows ones. 

[rwy12 16]

Hi 

Thank you for the advise. I have done this. Windows 10 refuses to recognize the yoke and the extra quadrant with no saitek drivers.

Can you please advise -can the extra quadrant be used on its own-or does it have to be connected via the yoke usb. I have tried directly and it doesn't get picked up by win 10?

[Kangaby 14]

Yoke and first quadrant (with the round plug) go together. The second quadrant can plug into any USB port.

[rwy12 16]

Thank you.

My extra quadrant only works if plugged into the yoke?

but the X and Y axis still not working.

If the extra quadrant is plugged directly into the  PC,should it work if the yoke is not connected to PC.

Mine doesn't

Sorry for all these issues?