F1 Cessna Citation has its own EZDOK view already setup..But it has this obnoxious hijacking of my Yoke's Trim switch buttons.

 

Everytime I use my elec trim switch, it changes my VC views. 

 

Where is this configured? so I can turn this off?

 

Anyone knows?

If I'm understanding the problem correctly - In the EZDOK studio whichever view is being changed by the trim button, will show up on the upper right side of Studio where the joystick button allocation is?

In this pic from the manual - joystick button 1 is controlling the forward view.

 

 

These can be deleted.

 

Eugene

Eugene

 

Hi Eugene

 

Let me check that again..But I doubt it cause I have assigned  a switch for my VC  in those two places.

 

Are there more than two such short cuts? 

 

Edited: 

 

Oh yeah...each of that view can have those two buttons assigned...

 

Ah ok..let me check each one of those views and remove that button or simply delete that view.. Thanks

Yup that did it... I deassigned them..

 

Thanks Eugene!