Camera editing 2nd problem.

[slip-stream 5]

For some reason I am unable to adjust via Pitch Bank or Yaw. 

 

Any reason why?

[Opus Software 84]

Need more information. What sim type? What OpusFSI version?

 

Check you have specified correct sim type etc. Check correct sim type is reported in Spy.

 

Do LCC adjustments work? Make sure you are in a correct view mode (VC etc..) as not all modes can be adjusted.

 

Stephen

[slip-stream 5]

I am trying to adjust camera views in VR Oculus rift CV1.  Running FSX SE

 

 

GEN  General process monitoring has been enabled ...

 GEN  Licenced User Name : keith sandford

 GEN  Licenced FSI Order : XXXXXX

 GEN  Input Device 1 : CYBORG 3D USB

 GEN  Input Device 2 : USB  ADAPTOR

 GEN  Site Effects : 97 Opus, 0 User, 97 in Total

 SIM  Connected to Simulator

 SIM  Air Folder = ND_CH47

Running OR CV1 and flyinside.

[Opus Software 84]

As I mentioned in another post, OpusFSI has nothing at all to do with OR.

 

OpusFSI DHM adjusts the eye point using SimConnect 6DOF requests.

FSX SE adjusts the displayed VC view.

OR renders that view onto the VR device.

 

These are all completely separate activities.

 

If you can see the DHM effects without the OR device then its working and is configured fine. After that the rest is down to the OR software.

 

Stephen :-)

 

P.S. I have to assume you have the most recent OpusFSI Release version 4.73 installed.

[slip-stream 5]

Stephen. Read the first post please. Nothing to do with DHM.

 

On a side note. How do I install latest version?

[Opus Software 84]

Too many posts ... just download the latest OpusFSI.msi, uninstall, then install the msi.

 

Do LCC adjustments work? Make sure you are in a correct view mode (VC etc..) as not all modes can be adjusted.

 

Stephen

[slip-stream 5]

Yes I can move forward back up down but cannot turn my head around. Bit annoying. Yes I'm in VC mode.

[Opus Software 84]

Explain how are you moving the eye point ? As there are no known problems with the software and if the XYZ translations work in LCC and camera editing then so should the rotation axes.

 

Are you using the LCC arrow keys in its dialog? Have you got an OpusFSI camera view you created on the display ? Remember only certain view modes can be controlled so select one of your opus VC camera views. But you wouldn't have been able to even edit the camera view without the eye point control.

 

Stephen

 

You can email me your cam file and I will take a look at your Config then assign some working keys etc..

[slip-stream 5]

Explain how are you moving the eye point ? By adjusting in the camera editing dialogue.

 

All left hand arrows work but none on the right hand.

[Opus Software 84]

Probably best to first upgrade to the latest OpusFSI.msi release version. Then we'll both be using the same software. Can you email me your CAM file located in your OpusFSI folder, I will load that tomorrow and get back to you after I've had a look at it.

 

Stephen