CH Throttle with Saitek Pro Flight Yoke

[mariosgers 0]

Hello everyone,

 

I am currently in the process of evaluating options to expand my flight sim hardware! I had the Saitek Pro Flight System (Yoke and Throttle) but i had a minor accident with the throttle and I need a new one. Seeing all the problems with the availability of it, I began to think about the CH throttle quadrant. My question is, will I be able to use Saitek's Yoke with it (or my Logitech attack 3 joystick) or will i have compatibility issues? I am currently using FSX:SE. 

 

Thanks a lot in advance, any advice on how to actually operate both at the same time is much appreciated!

[onebob 125]

Hello everyone,

 

I am currently in the process of evaluating options to expand my flight sim hardware! I had the Saitek Pro Flight System (Yoke and Throttle) but i had a minor accident with the throttle and I need a new one. Seeing all the problems with the availability of it, I began to think about the CH throttle quadrant. My question is, will I be able to use Saitek's Yoke with it (or my Logitech attack 3 joystick) or will i have compatibility issues? I am currently using FSX:SE. 

 

Thanks a lot in advance, any advice on how to actually operate both at the same time is much appreciated!

I don't have your setup but I do use a ch products yoke and Rudder pedals along with a Saitek x52 for the throttle. use quite few buttons on the x52 for EZdoc . (This for P3D .) never had any issues.

 

bob

[Bozdog 63]

I have  them both attached, use the Saitek throttle when flying a single seater, and the CH for 2 engines.  No conflicts at all, only thing is I haven't been able to do is  set up the CH to do reverse. So I use the Saitek throttle to put it into reverse.  I know you can but I struggled to on windows 7. Updated to 10 and haven't retried since as it is not a big issue for me.  I find it a good product (although I did get it cheap 2nd hand on ebay)

[planenut 19]

Hi,

 

I use the Saitek Pro Flight Yoke and two Saitek throttles (to control all my two engine planes).  I also use the CH throttle quadrant for landing gear, parking brake,  and my one 4 engine plane.   I use the toggle switches to control my EZDOK views.  Never had any problems.  Works fine.  I'm using Win 10 and P3d.

 

Jim

[mariosgers 0]

Thanks for your help! Do you configure them through fsuipc or the standard fsx config?

[planenut 19]

I calibrate everything through FSUIPC.

 

Jim