Ortho4XP Water showing up incorrectly

[KnightFlyer 43]

Not sure how exactly to remedy Ortho4XP taking the entire tile. Any advice?

[sizziano 172]

 

Not sure how exactly to remedy Ortho4XP taking the entire tile. Any advice?

 

Where is this exactly? Is it inland? There is an option to use masks for inland water bodies. There is also an option in the config file to use XP water instead of orthos that should solve this.

[KnightFlyer 43]

Ah. This is Lake Michigan right off of the Chicago skyline. I did check the option to use masks, but it created this result.

[sizziano 172]

Ah. This is Lake Michigan right off of the Chicago skyline. I did check the option to use masks, but it created this result.

 

Ah yes had the same issues. If you turn on the option to use XP water it should solve the issue. You can edit the config file in the Ortho4XP folder with Notepad++. Don't remember exactly what it's called.

[KnightFlyer 43]

Just found and tried

"water_overlay        = True

water_option         = 1            # 1 = X-Plane, 2 = Photoreal only, 3 = Mixed 

ratio_water"

Still having trouble :((

[sizziano 172]

 

Just found and tried

 

"water_overlay        = True

water_option         = 1            # 1 = X-Plane, 2 = Photoreal only, 3 = Mixed 

ratio_water"

 

Still having trouble (

 

 

Try turning off water overlay maybe?

[hjsmuc 393]

The right side of the screen shot shows that data in the desired ZL was not available by the selected provider. Try creating the tile again with lower ZL or another provider.