autobrake rto

[cannow 61]

Setting up from cold and dark panel state as per Fcom all fine until I start last engine and autobrake rto disarms and will not reset. Anybody got a clue what I am doing wrong if I load default panel state it will arm fine .

[rsrandazzo 6,353]

Colin,

 

I'll investigate and report back.

 

It should remain in RTO- that would be the correct behavior.

[cannow 61]

Thanks robert will wait to here back by the way excellant aircraft loving it so far.

[Boomer 1,619]

I will also try to replicate and report back.

[Spidierox 4]

I had that too.

What I did was I clicked on the spot where you can ARM the speedbrake in VC then again to disarm it.

After that I could have my autobrake set to RTO (which before I couldn't and the knob would spring back to OFF)

 

I was am happy again

[cannow 61]

I had that too.

What I did was I clicked on the spot where you can ARM the speedbrake in VC then again to disarm it.

After that I could have my autobrake set to RTO (which before I couldn't and the knob would spring back to OFF)

 

I was am happy again

 

Gave that a try tonight no joy same issue will not go to rto

[cannow 61]

Gave that a try tonight no joy same issue will not go to rto

 

Any update am I the only one having this issue

[downscc 1,327]

Create your own cold and dark panel state then run a trial and see if problem persists.  If not, it is a bug in the PMDG cold and dark panel.  I have only used it once myself and did not see the problem but that was during testing and things change.

[cannow 61]

Create your own cold and dark panel state then run a trial and see if problem persists.  If not, it is a bug in the PMDG cold and dark panel.  I have only used it once myself and did not see the problem but that was during testing and things change.

 

Yes that seems to have done it must be a bug in the cold and dark panel thanks